So apparently there is no programming software that comes with the UV920R. After a bit if searching and a few emails I got a copy.
So apparently there is no programming software that comes with the UV920R. After a bit if searching and a few emails I got a copy.
Hello – Thanks for your post and information, I did download the UV920R software. The file required WINRAR to unzip. I can open the software but I can not make a radio connection. At one point I could see the COM port in the device list, now it doesn’t show up at all. Also. nothing can be saved, I keep getting an excel error code that I can not copy to look up. All in all, the software lacks a great deal of simplicity. This should be much more user friendly and easier to use. I do have the programming for the KG-UV3D working….anyway if you have any suggestions I would appreciated.
Check out my recent post about errors with the software and see if that resolves your issue.
Otherwise send me a screenshot to va3isp@va3isp.com and i’ll try and help you out.
Sounds like a driver issue. take a look here: http://sites.google.com/site/spooktechengineering/products/wouxun/software
I am looking for a more RSS type software, like to set Deviation levels and control bandstops(actually, to shrink the TX bands,not to expand), have wouxun released anything like this??
There isn’t anything at the moment that will allow you to do that.
Hopefully once they have all the bugs worked out they will release a more fully featured software package.
Ah…. the “low mic gain” may be one issue I am talking about, I have low deviation on VHF(??I think it was) at 3 khz, while the UHF (??) was 5 khz and OK, I would think this was an alignment or design issue rather than just a menu setting issue
What is the pin for programer rg45 to rs232
As far as I know its all USB. I have asked for the pin out. Should get something tonight
Sorry I didn’t get back to you earlier Andre. I don’t have a pin-out. I have asked for it a few times but it doesn’t seem that they are willing to share that yet. When I get my new version of the radio I’ll take apart the programming cable and see if I can figure it out.
I got a copy of the program that you dont ned excel in your computer
SA6BSG/Mikael
Hi,it starts to load and i see “ConnUtal on Data” on radio,then i get “Fail connection ! Please check power on or well connected to the com port” is there a setting on the radio that needs turning on and if so which one,very frastighting or do you have any idears to fix this
Geoff
Make sure that your USB cable is properly installed.
Check the device manager on your computer under COM ports and make sure there are no Exclamation marks beside the device.
There are no specific settings on the radio. If the cable is properly detected it should be plug and play.
Thank you for your reply,device manager under port are fine,comes up as poert 5,& have unpluged and pluged in again and still get the same thing,i mite look at buying a other lead,thanks for your help,Geoff
Hi,i have programed by pc om memory it comes up with freq and i can see the + & – but when i try the repeater i dont get return from repeater,any idears pls
Geoff
can i connect to this to echolink Any one have micpin comfig pse tell
Hi i have program data cable for kg uv2d. Inedd to convert this cable to use with my new uv920. Somebody knows the pinout??
I need to change exit of my cable to a RJ45 connector.
Thanks